Thursday, December 1, 2011
BOOSTZILA Super charging system for installing Acura/Honda NSX
Preparatory steps for installing a fuel system
A: adjust the two seats to the full forward with full vertical seat back.
B: negative battery disconnect the cable.
C: remove 5 back inside the panels long segment begins across the car under the rear glass. Next remove two flat panes located behind the seats. Next remove the corner parts. Finally, remove the speaker, rear gate Assembly Center. (Long Board across there are 3 push lock the security PIN w/style barbed one at each end, one Center) (2 to 4 barbed flat push lock pins all security, w/all located with the help of a few inches at each corner of the panels) (Corner sections are held in place with 3 screws Phillips which became after vbmschim flat are removed)D: remove engine cover.
E: remove the strut brace engine compartment.
F: remove the air box Assembly stock.
G: remove the cover plate of the engine name, covers fuel rail ????????? metal gate Impetigo.
Height: carefully raise vehicle by the vehicle. If there is no elevator available vehicles use floor outlet. If using a floor Jack raise vehicle as high as possible to reach safely 4 Jack is the only appropriate under body factory recommended positions. The vehicle must be high enough to remove the fuel tank.
I: remove the rear wheels at this time.
Y. fuel tank fuel to relieve the pressure by the gas cap spreads.
