Thursday, December 1, 2011
1/5 scale Ducati 999R Nitro powered R/C motorcycle manual
Skip if already installed radio equipment assembled version RTR
A. install the receiver to switch to servo steering wheel servo mount with 2 screws.
B. install the Steering servo servo mount with four screws. (You must be centered note output shaft between the chassis frames.)
C. installing the servo servo mount with 4 throttle to press screws. Assembly location is shown in this guide.
D receiver device over the space between the two posts of the frame with tape both sides provided.
A. install the receiver at the bottom of the battery case. Then secure the battery pack with zip tie.
F. Verify that all cables are securely connected to the receiver servo Steering: connector insert – channel 1 Throttle servo connector slot plug-into the battery slot of channel 2 to insert author-the battery slot. Then concatenate the receiver antenna/antenna mount through the wire.
7. thread the string through each antenna/receiver antenna and the antenna tube to mount. Place the antenna on the supply tube to secure the antenna or antenna cable.
VIII. next, use cable or zip-tie tie the surplus from each organized wiring high temperature or moving parts.
