Thursday, December 1, 2011
Nemesis engine control for Ducati firmware update Guide
There is no reason why you can't apply this older software upgrade the hardware specification nemesis-003 changes. Change the hardware only refers to control air valve 003 for 1098, therefore you can use this software with hardware there is some level of 749 or 999-problem
In this release has the following improvements:
• Active air valve software
• Graphical map 2D editing of x and Y axis
• Interpolation editing allows you to map the minimum number of cells, and then interpolate between them to fill in the other cell values.
• Automatic or manual mode to adjust the process manually, you can make changes to the cell values that are written directly to the nemesis
• Buttons re set to go for more input count Max RPM
In this release has the following bug fix
• Maximum RPM value Latched stored as 65536 – fixed
• DJDInt-fixed value monitor page
• Ability to run the bike with side stand down grants no bike equipment
You will need to install all the following programs on your PC.
• Axide-
• Tiny BL
• Mon175 v 1.03
Remember to re-boot after installation
